Tuesday, September 16, 2008

Physical Computing Week 2 Homework

For week two I had to use a sensor(analog in) to send information to the Arduino that then used the data to regulate something else. In my case I used 3 potentiometers that controlled blue, green and red LEDs.

I wanted to create a way to make many different colors. I put the LEDs inside of a cube of foamcore with a paper window. Watch the videos to see how it went.


With the lights on so you can see the components.


Color Maker in the light from Matt Richard on Vimeo.


With the lights off so you can see it work.


Color Maker in the dark from Matt Richard on Vimeo.

3 comments:

  1. Cool stuff, did you use pulse width modulation or just resistance to dim the leds? I ask because you are going to want to mod it (in the future) to PWM as resistance generates a fair amount of heat (at the resistor which is a pot in this case) while PWM uses flicker to adjust the brightness and generates no heat. That project looks fun and the color is great! :)

    ReplyDelete
  2. OK, so I read through your post again and it looks like you are using the arduino (I believe that is an Atmega chip, right?) to monitor the voltage difference between two pins... or are you just reading the voltage in?

    How are you controlling the led brightness? Are you limiting the voltage from the arduino?

    ReplyDelete
  3. I have been a herpes carrier for 2 years and I tried every possible means of curing but all of no useful until I saw a health promotion on a herbalist from West Africa who prepares herbal medicines to cure all sorts of diseases including #HSV and many others sickness but look at me today am very much happy and healthy, I'm telling you today don't lose hope keep trying God is with you, If you needs Dr.Chala help contact him on his email dr.chalaherbalhome@gmail.com or you can visit his website on http://drchalaherbalhome.godaddysites.com or https://mywa.link/dr.chalaherbalhome

    ReplyDelete